Sliding Gate Preston

Preston Sliding Gate

Preston Sliding Gate

We were asked to design, supply and install a bespoke sliding gate at a new motorbike showroom in Preston. The gate is controlled via a keypad system to open and close the gate. Because of the location of the gate, speed was a requirement so we fitted a Tousek operator which opens the gate in an impressive 15-16 seconds. It also has the built in battery back up, so on a power failure the gate will still operate it.

All required safety edges and dual photocells have been fitted, as standard on all our sliding gate systems.

We were also tasked with manufacturing and installing 55 No. stainless steel hooped rails, these were spaced to prevent any un-authorised vehicles from entering the site. The hoops stand approximately 600mm high above the FFL and are 1.2m apart.

Sliding Gate Preston

Sliding gate Preston

Published On: June 25th, 2015